Weatherproof 40U Air Conditioner Type Outdoor Telecom Cabinet With Emerson Power Supply

Weatherproof 40U Air Conditioner Type Outdoor Telecom Cabinet With Emerson Power Supply

1 Product description

1.1 Appearance

After the cabinet is installed, as shown in Figure 1 and Figure 2

          Figure 1                                                                                                          Figure 2

1.2 Cabinet configuration

The outdoor integrated cabinet configuration of this project is as follows:

1.3 Cabinet size

The size of a single cabinet is shown in Figure 3 . External size: W×D×H 905×905×2107mm

                                                        Figure 3

1.4 Cabinet material

Sanwich structure panel, galvanized steel, double wall with heat insulation

2 Cabinet installation

2.1 Unpacking

Outdoor integrated cabinets are generally packed in wooden cases. When disassembling the package, take care to avoid damage to the cabinet.

2.2 Cabinet base

The size of the base of the cabinet and the fixing hole of the base expansion bolt are shown in Figure 4 .

                                                           Figure 4

2.3 Cabinet fixing

( 1 ) According to the hole position map or the scribe template of the cabinet base, the base expansion bolt hole of the cabinet is punched with a hammer drill in advance, and the diameter of the hole is referenced to the size of the expansion bolt;

( 2 ) First, fix the leftmost or rightmost first cabinet with expansion bolts, place the remaining cabinets one by one, and finally fix the cabinets with the expansion bolts.

( 3 ) If you need to seal the base of the cabinet, use the base sealing plate (optional) to seal the notch and hole around the base. The mounting screws are the M5 stainless steel screws in the cabinet attachment (see Figure 5 ).

Note: If the cement foundation is not flat, it is recommended to use a gasket or spacer to level the base of the cabinet.

                                                                        Figure 5

Note: When crossing the wire loop, first cut the cross with a utility knife. After the cable is connected, seal the remaining gap on the wire loop with the sealing glue attached to the cabinet.,As shown below;